🚀 go-pugleaf

I have an Adaptec 2742AT SCSI controller (twin controller for 
EISA bus). 

My original configuration only used A for the following devices
(in cable order):

	SCSI ID 4	HP Scanjet IIc (terminated)
	SCSI ID 5	Iomega ZIP drive (not terminated)
	SCSI ID 7	Controller A (not terminated)
	SCSI ID 0	Conner 1060S 1 gig hard drive (terminated)

Running under w4wg 3.11, 32 bit file access, 32 bit disk access.

In an attempt to get faster backups, I moved the hard disk to
controller B (which has internal connection only.)

	SCSI ID 4	HP Scanjet IIc (terminated)
	SCSI ID 5	Iomega ZIP drive (not terminated)
	SCSI ID 7	Controller A (terminated)
	
	SCSI ID 7	ControllerB (terminated)
	SCSI ID 0	Conner 1060S 1 gig hard drive (terminated)

Everything works fine under DOS, but when I bring up w4wg 3.11,
I get the message the file KRNL386.EXE could not be found.
Using DOS to examine the directory c:\win\system, the file is there.

If I revert to the original setup, w4wg works fine again.

Has anybody seen this before? . . . or have any ideas?

Any help appreciated.

firebird