🚀 go-pugleaf

On Wed, 25 Feb 1998 05:34:58 GMT,
terri24-nospam-@worldnet.att.net (Joe) wrote:

>I recently attempted overclocking my Diamond Stealth II to 50 MHz, but
>I noticed that it gets dangerously hot.  I have an old 486 heatsink &
>fan that I'd like to try attaching to the V2100 chip on the Stealth.
>What's the best way to do this?  I've seen people use everything from
>Super Glue gel to fish line to rubber bands.  What's a *sane*
>alternative to this?  

I'd find a high heat rated loc-tite and some thermal grease.
Swirl the thermal grease on in a donut fashion on the heat sink
bottom.  In the center of the donut, apply loc-tite.  Apply to
the chip.

Don't install the card for an hour, letting it set.  

Things to watch out for:

Check that heat rating on your loc-tite.

Make sure your clearance for your heat sink will be sufficient
once its on the chip and the card installed.

Will