Fujitsu SCSI terminating resistor

Article View: comp.sys.ibm.pc.hardware

Article #18891

Back to comp.sys.ibm.pc.hardware Previous Next

#18891

From: roger.h.levy
Date: Tue, 05 Jan 1993 15:02

13 lines
1215 bytes

I have a Fujitsu SCSI drive that I would like to relocate from a
configuration where the terminating resistor was not needed to
a configuration where it is (i.e. single drive).  The Fujitsu
appears to use a 20 pin DIP terminating resistor network.  I
called Fujitsu for this part but they have at least a 3 week
backorder delay and their minimum purchase and shipping charge
policy leave me unexcited about spending $16 for a resistor.
Does anyone know of an alternative source for this part - I have
found 16 pin terminating resistors to be common but I haven't
found a source for the 20 pin version.  BTW, I assume the
resistor network is the 220/330 ohm type - I'd like to know if
that assumption is wrong because I may just end up building
the part from resitors and a header.

Technical Details

Message-ID: <1993Jan5.150252.53@cbnewsl.cb.att.com>

Path:

arc1-ca.pugleaf.net!sparky!uunet!zaphod.mps.ohio-state.edu!cis.ohio-state.edu!pacific.mps.ohio-state.edu!linac!att!cbnewsm!cbnewsl!rl

Show Full Headers

Complete Article Headers

Newsgroups: comp.sys.ibm.pc.hardware
Path: arc1-ca.pugleaf.net!sparky!uunet!zaphod.mps.ohio-state.edu!cis.ohio-state.edu!pacific.mps.ohio-state.edu!linac!att!cbnewsm!cbnewsl!rl
From: rl@cbnewsl.cb.att.com (roger.h.levy)
Subject: Fujitsu SCSI terminating resistor
Organization: AT&T Bell Laboratories
Distribution: na
Date: Tue, 5 Jan 1993 15:02:52 GMT
Message-ID: <1993Jan5.150252.53@cbnewsl.cb.att.com>
Keywords: SCSI
Lines: 13