Hard drive WREN V with ESDI Interface jumper setting needed.

Article View: comp.sys.ibm.pc.hardware

Article #19394

Back to comp.sys.ibm.pc.hardware Previous Next

#19394

From: Marc Trottier
Date: Fri, 08 Jan 1993 14:46

19 lines
1129 bytes

I have an old CDC Wren V model 94186-383H ESDI interface, and I would like 
to use it as a second drive. Therfore, which jumper have be to set to get 
drive #1 instead of 0.

Looking underneath the drive, there is 2 sets of jumpers. One at the left of 
the terminators resistance and a second one at the right just underneath the 
power connection.
                                  -------
                                / * * * * \ power connection
                                ----------
    ||||| ............   ||||||| 
     ^ ^  Ter. Res.            ^

^ = jumper ON

Thanks in advance.   
 
 
 Marc Trottier / mtrottie@emr1.emr.ca

Technical Details

Message-ID: <mtrottie.33.0@emr1.emr.ca>

Path: arc1-ca.pugleaf.net!sparky!uunet!zaphod.mps.ohio-state.edu!cs.utexas.edu!torn!nott!emr1!mtrottie.mps.emr.ca!mtrottie

Show Full Headers

Complete Article Headers

Newsgroups: comp.sys.ibm.pc.hardware
Path: arc1-ca.pugleaf.net!sparky!uunet!zaphod.mps.ohio-state.edu!cs.utexas.edu!torn!nott!emr1!mtrottie.mps.emr.ca!mtrottie
From: mtrottie@emr1.emr.ca (Marc Trottier)
Subject: Hard drive WREN V with ESDI Interface jumper setting needed.
Message-ID: <mtrottie.33.0@emr1.emr.ca>
Lines: 21
Sender: news@emr1.emr.ca
Nntp-Posting-Host: mtrottie.mps.emr.ca
Organization: MPS, Energy, Mines & Resources, Canada
Date: Fri, 8 Jan 1993 14:46:04 GMT