🚀 go-pugleaf

I am running a 486DX33 and am having a problem with Microsoft windows.  I 
have already posted a request for help on this subject in 
Comp.Sys.Ibm.Pc, but have not gotten any responses of ANY sort.  Here is 
my problem.  I am Completely unable to access my modem from windows.  In 
fact, after I have exited windows, I am unable to use the modem, unless I 
re-boot the computer.  My hardware consists of the following:
486DX33 Motherboard, OPTI Chipset, AMI Bios.  64k Cache, 16Mb 70Ns ram, 
Trident 8900c 1Mb Svga Card, Multisync-clone monitor, Teac 1.2 Mb Floppy 
as drive A:, 1.44Mb as drive B:.  DTC 6282 ESDI hard drive controller, 
Maxtor EXT-4380 ESDI drive, MSC Compatible mouse connecxted to COM1: 
Com2: present, but no device connected.  Nuvotel 14400IFX V32.bis Modem 
on Com4:.
I am running QEMM386 under MSDOS 5.0, and sometimes also am running 
DesqView X.  I am NOT running Windows under DVX however.  I always start 
windows out from MSDOS, with no software other than QEMM running.

I apprecaite any help regarding this problem.
I realize that this may not be the CORRECT Newsgroup to post this to, but 
please do not flame me.  If this is the wrong place, please point me in 
the right direction.

Thanks,
Mark Mooney