🚀 go-pugleaf

>I post this about every two months hoping someone from HP will
>see it and come to my aid.  Still no luck, so here it is again.
>When I turn on my Vectra QS/20 ('386, A: = 1.2flop, B: = 1.44flop,
>C: = 32MB DOS partition, D: = 9 MB partition) it gives me an
>error code 9303, which someone once told me was a problem with
>disk drives.  Running SETUP helps none, as all the settings are
>correct.  (I told it there was no D drive, as there is really
>only one hard disk...is this right?)  Any ideas?  Thanks,

I was the one who said this was a disk error message. The 9xxx
are FLOPPY not hard disk errors. It's time to spend the money
to have a repair shop look at the system. You got a hardware
problem. It can be as simple as a loose cable or as bad as a 
bad motherboard.  It's time to have someone with hardware expertise 
take a hands on look at the system. 

			   Danny Low
    "Question Authority and the Authorities will question You"
	   Valley of Hearts Delight, Silicon Valley
	     HP NPCD   dlow@pollux.svale.hp.com