🚀 go-pugleaf

In article <3078@orbit.cts.com>, griggs@pnet51.orb.mn.org (Griggs Nichols) writes:
> Batch file aficionados, I need some help.
>    
> I am trying to figure out a way to read/verify a VOL label on a disk in drive
> A, through a command line in a batch file.
>   
> Currently I am using an IF...EXIST line which looks and verifies the existance
> of a dummy text file on the disk.  Because this takes up precious room on the
> disk, I'd like to be able to just verify the label.  BTW, I am using DOS 3.3.
> I know that MS-DOS 4.01 has the ability to recognize serial numbers for
> individual disks, and this problem is sort of addressed in the current
> PC/COMPUTING magazine.
>    
Not an answer to your question, but an alternative solution.
Try using the following command at the DOS prompt :
A:> REM > filename.ext

Then use IF EXIST filename.txt to test for the existence of the
file.  The above method will create a directory entry only on
the disk, and does not take up any room on the disk.

===================================================================
Henry Esbenshade  email: h_esben%vaxa.uwa.oz   phone: 09 380 3435
                                                 fax: 09 381 6427
Department of Geography, University of Western Australia
Nedlands, Western Australia, 6009,  Australia