🚀 go-pugleaf

/ mcphail@dataco.UUCP (Alex McPhail) /  3:55 am  Jan 24, 1991 / writes:

$ I have MKS Toolkit, and DesqView (the latest version).  When I
$ try to run 'vi' in MKS Toolkit while I am in a DesqView window,
$ it starts to run, then it beeps forever.  I can get Deskview's
$ attention with the ALT key, but the beeping doesn't stop until
$ I actually close the window.
$ 
$ My vi works perfectly otherwise (ie: not under DesqView).  I
$ have a 386SX with 2M RAM.
$ 
$ Does anyone out there have any ideas?  Have you had this
$ problem before?
$ 
Co-incidentally, I have seen exactly this problem on my 25 MHz 386 before.
I was using DesqView 2.26 and QEMM 4.23 then. I can't remember if I tried
after upgrading to QEMM 5.0. I thought it was probably some compatibility
problems with my 386 then. So, I didn't ask the net.  May be using
DesqView 2.30 will solve the problem. .... but I don't use DesqView 
anymore. .... I just like Windows more .... No flame ..

$ Thanks in advance.
$ 
Sorry I can't give you a verified fix.


Regards,     . .. ... .- -> -->## Life is fast enough as it is ........
Peter Lim.                     ## .... DON'T PUSH IT !!          >>>-------,
                               ########################################### :
E-mail:  plim@hpsgwg.HP.COM     Snail-mail:  Hewlett Packard Singapore,    :
Tel:     (065)-279-2289                      (ICDS, ICS)                   |
Telnet:        520-2289                      1150 Depot Road,           __\@/__
                                             Singapore   0410.           SPLAT !

#include <standard_disclaimer.hpp>