Article View: comp.sys.ibm.pc.misc
Article #711Re: Stacker and QEMM optimize question?
From: William F. Baker
Date: Mon, 06 Apr 1992 15:54
Date: Mon, 06 Apr 1992 15:54
12 lines
1294 bytes
1294 bytes
In order to run optimize, you have to REM out the statement in config.sys that runs
sswap.com, then change all references to c: to d: following the sswap command. You'll
also need to make these changes (c: to d:) in your autoexec.bat and any other file
that refers to your c drive at the boot sequence. In addition, you'll have to copy
your autoexec.bat file to the same drive that your config.sys is on now. When you're
all done, reverse the process (I'm assuming that you're using sswap). It's kind of a
pain, but I use it and it works fine for me.
---
Bill Baker ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
baker@stortek.com | So many assholes...so few bullets - Ford Fairlane |
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Technical Details
Message-ID:
<1992Apr6.155406.3664@stortek.com>Path:
arc1-ca.pugleaf.net!sparky!uunet!zaphod.mps.ohio-state.edu!magnus.acs.ohio-state.edu!csn!stortek!lhotse!bakerReferences:
<11763@tamsun.tamu.edu>Show Full Headers
Complete Article Headers
Newsgroups: comp.sys.ibm.pc.misc Path: arc1-ca.pugleaf.net!sparky!uunet!zaphod.mps.ohio-state.edu!magnus.acs.ohio-state.edu!csn!stortek!lhotse!baker From: baker@lhotse.com (William F. Baker) Subject: Re: Stacker and QEMM optimize question? Message-ID: <1992Apr6.155406.3664@stortek.com> Sender: usenet@stortek.com Nntp-Posting-Host: lhotse.stortek.com Reply-To: baker@lhotse.com Organization: Storage Technology Corporation References: <11763@tamsun.tamu.edu> Date: Mon, 6 Apr 1992 15:54:06 GMT