🚀 go-pugleaf

In article <3360011@hpsgwp.sgp.hp.com> plim@hpsgwp.sgp.hp.com (Peter Lim) writes:
</ mcphail@dataco.UUCP (Alex McPhail) /  3:55 am  Jan 24, 1991 / writes:
<
<$ I have MKS Toolkit, and DesqView (the latest version).  When I
<$ try to run 'vi' in MKS Toolkit while I am in a DesqView window,
<$ it starts to run, then it beeps forever.  I can get Deskview's
<$ attention with the ALT key, but the beeping doesn't stop until
<$ I actually close the window.
<$ 
<$ My vi works perfectly otherwise (ie: not under DesqView).  I
<$ have a 386SX with 2M RAM.
<$ 
<$ Does anyone out there have any ideas?  Have you had this
<$ problem before?
<$ 
<Co-incidentally, I have seen exactly this problem on my 25 MHz 386 before.
<I was using DesqView 2.26 and QEMM 4.23 then. I can't remember if I tried
<after upgrading to QEMM 5.0. I thought it was probably some compatibility
<problems with my 386 then. So, I didn't ask the net.  May be using
<DesqView 2.30 will solve the problem. .... but I don't use DesqView 

I missed the start of this thread, but I have an idea anyway..

When using an initial screen size of 50x80 for a desqview window,
DV does not correctly program the screen buffer length.  It leaves it
set to 4096, which would be correct for a 25x80 screen size.  DV does 
set the rows/columns variables (BIOS stuff) correctly, but seems to miss
out on the buffer size.  This causes ELVIS (a VI clone) to mess up under
desqview.  Perhaps MKS has the same troubles?  

Then again, maybe my machine is weird, and nobody else has this problem.
-- 
 ___Mark S. Lord__________________________________________
| ..uunet!bnrgate!mlord%bmerh724 | Climb Free Or Die (NH) |
| MLORD@BNR.CA   Ottawa, Ontario | Personal views only.   |
|________________________________|________________________|