🚀 go-pugleaf

I'm a graduate student on a tight budget, so that should answer the 'why.'

I had an XT in which I used a ST-225 20 MByte disk on a Western Digital
Controller (marked WDC 60... on the card).  I bought a bare AT which
uses an IDE controller.  It currently has the hard disk controller dis-
abled.  BTW, it has AMI bios, and I set the CMOS appropriately.  

The whole PC just locks up when I boot with the hard disk installed.
I'm using it fine right now from floppy.

I have moved the disk from XT to XT over the years with no problem.
Ideally, I would use it in the AT without reformatting -- leave all
the data 'as is' on the disk.  

Is this possible?  Or should I hook it to the IDE controller?  
Even some general help would be appreciated, or a pointer to a good
book on the subject.  Time is cheap, but I ain't got no money for
a consultant or a better disk.

Thanks in advance.

Eric C. Jung
160 S. Virgil Ave. # 219            jung@usc.edu 
Los Angeles, CA  90004                 A.K.A.   
213-385-7156