Mattel PowerGlove Software Interface

Article View: comp.sys.ibm.pc.programmer

Article #1008

Back to comp.sys.ibm.pc.programmer Previous Next

#1008

From: Daniel Reed
Date: Mon, 23 Jul 1990 17:06

19 lines
1225 bytes

The July '90 issue of byte contains a description of a hardware
and software interface that will allow the Mattel/NES Powerglove
to be used on an IBM PC compatible.  I have a Powerglove and the
necessary hardware, but I need a copy of the assembly program PG.COM,
part of which is listed on page 289 of the July '90 Byte issue?  
The article says it is available from BIX ...

Does anyone out there have a copy of the code that they could send me?
I don't want to wait the two-four months needed to get a copy from
Byte, and I'm not a BIX subscriber.

Many thanks,

Daniel A. Reed
Department of Computer Science
University of Illinois
Urbana, Illinois

reed@cs.uiuc.edu

Technical Details

Message-ID: <1990Jul23.170617.10037@ux1.cso.uiuc.edu>

Path:

arc1-ca.pugleaf.net!utzoo!attcan!uunet!decwrl!sdd.hp.com!zaphod.mps.ohio-state.edu!brutus.cs.uiuc.edu!ux1.cso.uiuc.edu!oboe.cs.uiuc.edu!reed

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!decwrl!sdd.hp.com!zaphod.mps.ohio-state.edu!brutus.cs.uiuc.edu!ux1.cso.uiuc.edu!oboe.cs.uiuc.edu!reed
From: reed@oboe.cs.uiuc.edu (Daniel Reed)
Newsgroups: comp.sys.ibm.pc.programmer
Subject: Mattel PowerGlove Software Interface
Keywords: powerglove, Mattel, BIX
Message-ID: <1990Jul23.170617.10037@ux1.cso.uiuc.edu>
Date: 23 Jul 90 17:06:17 GMT
Sender: usenet@ux1.cso.uiuc.edu (News)
Reply-To: reed@oboe.cs.uiuc.edu (Daniel Reed)
Organization: University of Illinois at Urbana-Champaign
Lines: 19