386 Protected Mode Interrupt Table..HELP

Article View: comp.sys.ibm.pc.programmer

Article #1333

Back to comp.sys.ibm.pc.programmer Previous Next

#1333

From: Alan S. Shih
Date: Sat, 24 Feb 1990 23:58

15 lines
1057 bytes

   Are there anybody who know how to switch interrupt table from real
   mode to protected mode? I know that interrupt table is only
   relative with IDT, however, is the memory address for there bios
   routine still the same? 
   I am trying to write a OS for my 386 which hopefully will utilize
   my vga + multitasking.  Any advise is appreciated!

Alan Shih


\_______________________________________________________/
 |						        |
 |	Alan Shih					|
 |							|

Technical Details

Message-ID: <6840@ucdavis.ucdavis.edu>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!ucdavis!iris!shih

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!ucdavis!iris!shih
From: shih@iris.ucdavis.edu (Alan S. Shih)
Newsgroups: comp.sys.ibm.pc.programmer
Subject: 386 Protected Mode Interrupt Table..HELP
Keywords: INT, 386, protected  mode
Message-ID: <6840@ucdavis.ucdavis.edu>
Date: 24 Feb 90 23:58:57 GMT
Sender: uucp@ucdavis.ucdavis.edu
Reply-To: shih@iris.ucdavis.edu (Alan S. Shih)
Distribution: comp.sys.ibm.pc.programmer
Organization: U.C. Davis - Department of Electrical Engineering and Computer Science
Lines: 15