🚀 go-pugleaf

I found the pinouts for the 4-port card, which I assume are the same
as the backplane ports.   I am now trying to connect the serial
port to a Bridge Communications Server/100, and run ATE (I know)
to pretend my RT is a VT100.  I am using the following cable
connection:
 
       2 Transmit Data  <------->   Receive Data     6
bridge 3 Receive Data   <------->   Transmit Data    1
       7 Signal Ground  <------->   Signal Ground    10    RT (10-pin)

      20 DTR            <---+--->   DTR              2
                            |--->   DSR              7
      ^                     +--->   Carrier Detect   9
db25 pin
                             +-->   RTS              3
                             |-->   ring             4
                             +-->   CTS              8

I added tty0 with devices, auto-enable is off, etc., I configured it
just like an internal modem I have that works on another machine.  ATE
(all set up to talk, no modem control strings, parity, baud, #bits,
stop, mark, etc. are set identically to a terminal that works
when connected to the same cable.  ATE thinks that it gets
connected (not surprising), but no data over the wire.  If you
can tell me how to fix this, I will be most grateful!

Thanks---
John-- 
...................................
John Bunda            UT CS Dept.      
bunda@cs.utexas.edu   Austin, Texas