🚀 go-pugleaf

Hi,

I have just got hold of most of an IBM RT 125 (6150) and I need help, information and even some hardware....

The system is a Landmark Graphics system, comprising:
	RT Advanced Processor Board
	2x4Mb fast memory boards
	SCSI interface
	Micom interlan NP600A-3 ethernet adaptor
	2xImagraph L10AGC1210-10P video(?) adaptor cards, 1 linked to
	Imagraph Sega layer 6 card with NSI Logic daughter board
	Wietek 300-0046-00 with 3002-0047-00 daughter card (?)

The system has 3 internal hard drives (310Mb each I think) and the obligatory floppy drive. The system came with two Sony Trinitron GDM-1950 monitors and an enormous rack box containing yet more hard disks, a 9 track tape and an optical disk drive for huge read/write optical disks.

However, there is *NO* keyboard, *NO* mouse, *NO* cables & *NO* documentation. I have switched the box on & it runs through it's self tests on the small led with no apparent problem, then sits quite happily humming away, but I can't tell what's really happenning without a keyboard and a monitor cable. 

I can get hold of an old IBM PC keyboard, but it has a 9 pin DIN plug connector rather than the RT type, are the keyboards compatible if I change the plug? does anyone have the pinouts for the mouse, kbd & serial ports? Better yet, does anyone have unwanted RT keyboard & mouse I can buy (cheap + carriage)?

I also need to know cable spec's for the Imagraph card->GDM1950. 
The monitors have 5 BNC connectors; R, G, B, HD & VD, the last two being 		sync in connections. 

The Imagraph L10AGC1210-10P cards each have 9pin female D type 	connectors

The Imagraph Sega Layer card (to which one of the Imagraph L10* cards is linked via a short ribbon cable) has a 9 pin female D type and a 25 pin female D type connector, none of which are labelled.

I have no idea what the wietek card is or what it does.

In summary:
	1) does anyone know the (monitor etc) cable spec for this system?
	2) Can I use a standard PC keyboard, and if so how do I convert from 5 			   pin DIN to RT 6 pin square? Can I convert Logitech mouse (Logimouse 			   P7) with 9 pin D type to RT 6 way?
	3) Does anyone have surplus RT keyboard & mouse?
	4) What is the pinout for the serial ports s1 & s2?
	5) Does anyone know of a Landmark Graphics Corporation contact?
	6) What is AOS 4.3 or 4.3/RT?
	7) Anyone tell me anything else about this system?

Massively grateful for any help/comments, please feel free to mail me direct, (it's a bit easier for me that way), or via NEWS...

Simon
------------------------------------------------------------------------------
  Simon Greaves                                    Systems & Comms programmer
  Phone:  +44 31-451 3265 (External)               Room 11, Computer Centre,
           Ext 3265        (Internal)              Heriot-Watt University,
  Fax:    +44 31-451 3261                          Edinburgh, EH14  4AS
  Janet:  censjg@clust.hw.ac.uk                    Uk