🚀 go-pugleaf

In article <807@meaddata.mead.UUCP> brad@mead.UUCP (Brad Craig) writes:
>    I'm trying to write write some data to a tape from an RS 6000, and
>then read the tape on an RT 125.  The RS is running with the 9021
>build of version 3.  The RT is running version 2.2.1.  SO far I have
>not been able to read any tape on the RT that was created on the RS.
>I have attempted everything from dd to backup.  I have used the '-o'
>flag with the backup command, just as it is stated in the manual page.
>I also set the ECC flag to disable for the tape device (instructions
>form IBM), using smit.
>
>     I am using an RT 125 with a high-density tape drive.  (don't know
>the model right off hand, but it is an IBM drive)
>

Brad, place a hardware service call for the tape drive and specifiy that
you require the hardware EC that allows tape interchange with the RT
(specifically EC 844345).  I'm assuming you have a loaner machine from
the AIX Porting Center.  These machines require a hardware upgrade.

The other steps you've done are also required (no ECC, -o on backup).

Hope this helps.
-----------------------------------------------------------------------------
Ken Dillman           | 11400 Burnet Road | Phone: T/L 678-4804 or
AIX Technical Support | Austin, TX  78754 |            512/838-4804
ZIP 2830              |                   | VNET/PROFS: KDILLMAN at AUSTIN