tcp/ip over ethernet

Thread View: comp.sys.ibm.pc.rt

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Robert W Hetrick Wed, 26 Jun 1991 19:34

#1266

Author: Robert W Hetrick
Date: Wed, 26 Jun 1991 19:34

17 lines
1670 bytes

From: hetrick@matt.ksu.ksu.edu

Subject: Problems with using TCP/IP in connecting an IBM-PC to an IBM-RT.

I am using an IBM-RT model 6150-135 running AIX ver 2.2.1 and TCP/IP. I am
trying to connect an IBM-AT clone using Clarkson University's public domain
TCP/IP (TN3270). I can perform a ping within the RT and have no problem, 
however, when I ping for the PC, no response. I have used the netstat command
to retreive the hardware address and have plugged that into the arp table. I 
have looked into about every nook and crevice on the RT for address locations
and I have exhasted the knowledge of the area IBM network representative. I 
am using a 3-Com ethernet card with a built in transceiver on the PC and an
IBM Baseband Adapter eternet card on the RT. When I try to connect from the PC,
I get the message that Local or Gateway host not responding. Questions. Does 
anyone use TCP/IP on an RT in a similar setup? If so, what's the secret? I am
about to try a separate transceiver on the PC side as a last gasp measure. Let
me know if you have any ideas. Thanks.

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads