Problems with CADAM

Thread View: comp.sys.ibm.pc.rt

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Loren G. Brewster Tue, 30 May 1989 21:17

#1814

Author: Loren G. Brewster
Date: Tue, 30 May 1989 21:17

14 lines
1300 bytes

I recently installed Professional CADAM on an RT and when I tried to run it
I would get memory fault errors.  There would be a number preceding the
error message and the value would change (increase) each time I would run it.
Sometimes I would get the error message Memory Fault - Core dumped, other times
I would just get Memory fault.  In the instructions it says to install Personal
graPHIGS and the graphics interfaces which I did.  Any help would be greatly
appreciated.
-------
______________________________________________________________________
|                               |               \                    |
|  Loren G. Brewster            |  LXB104@PSUVM   \  Where ever you  |
|     Penn State / York Campus  |  LXB104@PSUSUN01  \    go,there    |
|     York Pa.                  |  TIMELORD@DRYCAS    \    you are.  |
|_______________________________|_______________________\____________|

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads