SIGNAL conversions

Thread View: comp.sys.ibm.pc.rt

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Thom Rounds Tue, 07 Aug 1990 03:36

#820

Author: Thom Rounds
Date: Tue, 07 Aug 1990 03:36

9 lines
576 bytes

    Howdy, howdy, howdy...
 
    Need ehlp from ANYONE regarding conversion of SIGTSTP signal to their AIX
counterpart. i.e. I need to patch this code and need to call SIGTSTP something
else. What should I use?
 
Thom Rounds
tar@Maine.caps.maine.edu

Re: SIGNAL conversions

#830

Author: drake
Date: Wed, 08 Aug 1990 16:56

14 lines
1206 bytes

In article <90218.233632TAR@MAINE.BITNET> TAR@MAINE.BITNET (Thom Rounds) writes:
>    Need ehlp from ANYONE regarding conversion of SIGTSTP signal to their AIX
>counterpart. i.e. I need to patch this code and need to call SIGTSTP something
>else. What should I use?

Which version of AIX?  On AIX PS/2 and AIX Version 3 (for the RISC System/6000),you'd just use SIGTSTP.  In AIX Version 2 on the RT there's no equivalent,
as that version doesn't support job control.  If on the RT, you'll just have
to no-op the code that uses SIGTSTP, since your application will never get it
anyway.

Sam Drake / IBM Almaden Research Center 
Internet:  drake@ibm.com            BITNET:  DRAKE at ALMADEN
Usenet:    ...!uunet!ibmarc!drake   Phone:   (408) 927-1861

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads