🚀 go-pugleaf

"Tim Mavers" <webview@hotmail.com> wrote in message
news:3d668623$0$212$45beb828@newscene.com...
> I have a SB Audigy Gamer with WinXP Pro. I have the latest drivers and
> patches for both.  This is all connected to a Klipsch 4.1 speaker setup.
>
> The problem is that when I perform the surround speaker test from the
> Creative Surround Mixer's "Speaker" tab in Advanced Settings, I hear each
> speaker pos and number correctly, but my rear left is ALWAYs louder
> (noticably).  I have fiddled with all the settings I can find, made sure
the
> wiring is correct, etc. but can't figure out why this one channel is
> noticibly louder than the rest.
>
> I suspect my Klipsch speaker connections (inside the speakers themselves)
> are a bit loose (as I have to wiggle the cord to get the connection "just
> right", else no sound out of that particular speaker), could this be the
> problem?   I would think so, but the remaining 3 speakers are quieter than
> the rear left.
>
> Thanks,

I had a similar problem with one of my Klipsch speakers being way
too soft - almost inaudible. Wiggling the cord sometimes fixed it.
But by switching the cords from one speaker to another I found
that the speaker was not at fault and the trouble really seemed to
be where the cord plugged into the sound card. Pulling the jack
out of the sound card, pushing it back in, and twisting it around
had much more consistant results than just wiggling the cord.
I have an SBLive Value, not an Audigy, but it sounds like a
similar problem.