🚀 go-pugleaf

I'm fairly new at complex batch programming, and I've made the discovery that
the DOS 3.3 manual isn't very helpful.

I'm trying to create a program to copy files from floppy to hard disk.  The
program should be able to handle a varying number of floppys - as entered
from the command line.

My question is how do I set up the counter variable in the program so that
I can loop through the copying routine for each disk?

I tried setting an environment variable to 0, then incrementing the
environment var, but that didn't work at all.

How do I create and use a variable in a batch program, and if I can't,
how do I code it to loop a variable number of times?

Any and all help/suggestions are welcome and greatly appreciated.

PS - please e-mail, I don't get much time to read this...

B

-------------------------------------------------------------------------------
"Just the opinions, ma'am."  |   Brett Shepard         | Close your eyes and 
Go ahead, crash our system!  |   Ball State University | pretend that there is
UUCP:  shepard@bsu-cs.bsu.edu|   Muncie, IN            | a fancy graphic here
-------------------------------------------------------------------------------