🚀 go-pugleaf

In article <217@slovax.UUCP> ira@slovax.UUCP (Ira G. Chayut) writes:
>I have received a used IBM PC with a 40 meg Tulin hard disk and a DTC
>controller.  Unfortunately, the system believes that it has a 10 Meg
>disk.  The system is now running Venix.  FDISK tells me that I have a 10
>Meg disk.  I would appreciate knowing how to tell the system that the disk 
>is really a 40 Meg disk?  (A diagnostic program that came with the system 
>scanned the disk and verified the size).

Last time I installed a drive, it was a 72Mb drive by Micropolis.  One
of the procedures you had to do was run the IBM diagnostic program (this
was an AT, but I expect a PC has a similar procedure) and tell it what
"type" of drive you had.  It's a number, usually 1-6 I think.  The number
is stamped on IBM disks -- with ours, the documentation told you what to
set.  I think that the diagnostics program informs the drive controller
what to make of the drive.

If the PC doesn't have something like this in its diagnostics, check the
drive controller documentation and it probably will fill you in.  It may
be a dip switch setting.

Actually, if the drive installation documentation didn't tell you how to 
do this, you should complain.
-- 
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
                   - Jim Frost * The Madd Hacker -
UUCP:  ..!harvard!bu-cs!bucsb!madd | ARPANET: madd@bucsb.bu.edu
CSNET: madd%bucsb@bu-cs            | BITNET:  cscc71c@bostonu
-------------------------------+---+------------------------------------
"Oh beer, oh beer." -- Me      |      [=(BEER) <- Bud the Beer (cheers!)