AT Interrupt Controller Programming Question

Article View: comp.sys.ibm.pc

Article #40363

#40363

From: Hennessey
Date: Wed, 27 Dec 1989 13:56

20 lines
1081 bytes

I have a interrupt-driven serial port driver that works fine on the PC, but
does not work on an AT. It seems that some interrupt occurs, and the controller
is not reset, causing a lack of interrupts.

If I remember correctly, the AT computer uses 2 8259A interrupt controllers.,
instead of one like the PC.

I need programming details: 

  Where is the second chip (I/O addresses A0 and A1???)

  What does the second chip service?

  How do you set the interrupt mask register (I/O port 21 on the PC)

  How do you reset after servicing the interrupt?

Thanks...

Dave (301) 227-1400

Technical Details

Message-ID: <695@nems.dt.navy.mil>

Path:

arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!samsung!uakari.primate.wisc.edu!ark1!nems!dtrc!hennesse

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!samsung!uakari.primate.wisc.edu!ark1!nems!dtrc!hennesse
From: hennesse@dtrc.dt.navy.mil (Hennessey)
Newsgroups: comp.sys.ibm.pc
Subject: AT Interrupt Controller Programming Question
Message-ID: <695@nems.dt.navy.mil>
Date: 27 Dec 89 13:56:40 GMT
Sender: news@nems.dt.navy.mil
Reply-To: hennesse@dtrc.dt.navy.mil (David Hennessey)
Organization: David Taylor Research Center, Bethesda, MD
Lines: 20