🚀 go-pugleaf

I have a 386 20mhz PC with motherboard produced in Taiwan. It has
the C&T CHIP set, and AMI BIOS dated 4-30-89. This system came with
1 MB of ram on the motherboard via 4 SIPP modules. I ordered 4 1MB
SIPP modules in order to expand the memory to 4MB (1MB conventional+
3MB extended RAM).

Apparently, the 4 256K SIPPS cannot be replaced with the 4 1MB SIPPS
and everything works fine. I tried this, the PC just beeps at me 
annoyingly. In the very brief manual that I have they make mention
of a set up program called SETUP386.com which is suppose to store
the appropriate information for the registers in CMOS. This is 
apparently a program that gets run upon system bring-up. But I don't
have this program.

Is this needed? Did the company not send it to me because their is an
easier way to do this?   If so please let me know how.

There is a setup routine in ROM that I can gain access to but I don't 
think it's the avenue to take, becuase I tried changing register values
to accomodate 1MB SIPPs in Bank 0 and 1, and insured interleave mode
was off, but after powering down, pulling 256K SIPPs and replacing
1MB SIPPs then powering back up, the boot screen still just shows 640K
with no extended memory. 

Any suggestions folks? What do I try next? Anyone else with similar
Motherboard get upgraded OK  

Thanks ---- Mark


-- 
Mark Gustoff - WO7T
P.O. Box 42742
Phoenix, AZ 85080