🚀 go-pugleaf

In article <12662@cbnews.ATT.COM> h7@cbnews.ATT.COM (c.f.hempstead,54234,wi,2n028,508 374 5423) writes:
>What is the proper sequence for turning on your CPU and your monitor
>when using a modern VGA card and a multiscan (multisynch) monitor?
>I'm using the ATI VGAWONDER card to drive a SONY 1304 monitor, and 
>when the two are turned on simultaneously, the monitor often comes up
>in a non-synched mode, with the successive scan lines such that the
>characters are unreadable.  The VGA driver card is supposed to "read"
>the monitor type (single scan frequency, or multiple), and automatically
>adjust itself.  Thus, it seems that the monitor should be turned on 
>first, so the driver can "read" it.  But it probably isn't good for
>a multiscan monitor to be running "open loop" very long, and if the
>problem is caused by the driver card, perhaps it should be turned on
>first, and then the monitor.  Explanations, suggestions welcome.

I am using a Fastwrite VGA card and Panasonic Panasync C1391 monitor (Very nice
monitor actually, and a lot cheaper than Sony's or NEC, and look just as good)
an I need to turn the monitor on first or at the same time as the computer or
the fastwrite can't read it's type correctly and just gives me black and white.
No sync problems though.

Russ Poffenberger               DOMAIN: poffen@sj.ate.slb.com
Schlumberger Technologies       UUCP:   {uunet,decwrl,amdahl}!sjsca4!poffen
1601 Technology Drive		CIS:	72401,276
San Jose, Ca. 95110
(408)437-5254