Article View: comp.sys.ibm.pc
Article #41539Re: BocaRAM expansion board
From: Paul P. Austgen
Date: Thu, 01 Feb 1990 15:56
Date: Thu, 01 Feb 1990 15:56
6 lines
707 bytes
707 bytes
I tried this board, but without the extra I/O ports. I had a AT clone that I believe runs the bus at full processor speed, 10 Mc. The board did not work unless parity was disabled. This no doubt was the fault of the bus design, but nonetheless, an AST Rampage board works just fine.
Technical Details
Message-ID:
<11250127@hpldola.HP.COM>Path:
arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!mips!apple!agate!ucbvax!hplabs!hpfcso!hpldola!ppaReferences:
<5190071@hplsla.HP.COM>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!mips!apple!agate!ucbvax!hplabs!hpfcso!hpldola!ppa From: ppa@hpldola.HP.COM (Paul P. Austgen) Newsgroups: comp.sys.ibm.pc Subject: Re: BocaRAM expansion board Message-ID: <11250127@hpldola.HP.COM> Date: 1 Feb 90 15:56:54 GMT References: <5190071@hplsla.HP.COM> Organization: HP Elec. Design Div. -ColoSpgs Lines: 6