🚀 go-pugleaf

|Does anybody know of a program, either PD or commercial, which will read
|BAUDOT input from a serial port and convert it to ASCII, to output on 
|another serial port?
|
|If not, does anybody know of a board that will do this?  This would be 
|very helpful for allowing me to send data to a commercial ASCII printer,
|instead of an EX$PEN$IVE BAUDOT teletype printer.

Bill,

The Baudot code is very simple, only 5 bits per character with a
shifted set to give a total of 64 symbols. UARTs can be programmed to
accept 5 bit characters though you may in some cases need to make
special hardware arrangements for the low baud rates. A simple
table-driven routine that remembers the shift state will do what you
want. For the Baudot code set, see a ref book like McNamara's
Technical Aspects of Data Comm.