Article View: comp.sys.ibm.pc
Article #42778Re: BAUDOT => ASCII Conversion
From: Wm E. Davidsen Jr
Date: Wed, 21 Feb 1990 04:42
Date: Wed, 21 Feb 1990 04:42
15 lines
1182 bytes
1182 bytes
At typical baudot data rates you can probably write the program in
BASIC and still have it work. Just init the ports, loop reading the
input until data available, read the port and store to the output.
Assuming that the printer is faster than the data coming in you don't
even need to check for ready on the output port, and certainly don't
need int4rrupts or something like that.
This can be done with about ten lines of slop programming, assuming
that you have the baudot to ASCII conversion table handy (I don't).
--
bill davidsen - davidsen@sixhub.uucp (uunet!crdgw1!sixhub!davidsen)
sysop *IX BBS and Public Access UNIX
moderator of comp.binaries.ibm.pc
"Getting old is bad, but it beats the hell out of the alternative" -anon
Technical Details
Message-ID:
<513@sixhub.UUCP>Path:
arc1-ca.pugleaf.net!utzoo!attcan!uunet!crdgw1!sixhub!davidsenReferences:
<1500@bmers58.UUCP>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!crdgw1!sixhub!davidsen From: davidsen@sixhub.UUCP (Wm E. Davidsen Jr) Newsgroups: comp.sys.ibm.pc Subject: Re: BAUDOT => ASCII Conversion Keywords: BAUDOT, ASCII, ITA-2, conversion Message-ID: <513@sixhub.UUCP> Date: 21 Feb 90 04:42:40 GMT References: <1500@bmers58.UUCP> Reply-To: davidsen@sixhub.UUCP (bill davidsen) Organization: *IX Public Access UNIX, Schenectady NY Lines: 15