Re: 386 instructions

Article View: comp.sys.ibm.pc

Article #8665

#8665

From: Jochen M. Fritz
Date: Tue, 16 Jan 1990 01:50

8 lines
803 bytes

I am not an assembler programmer (yet?), but this kludge might just work.
Look up the opcodes to all the instructions you wish to use in some 386 
reference manual.  Then define these as macros for the assembler with define
byte operator.  This will directlly insert the code into your assembler.

Hope this works  (feedback welcome!)
Jochen Fritz ("Noah")
joefritz@pawl.rpi.edu

Technical Details

Message-ID: <84Q0M&@rpi.edu>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!uwm.edu!rpi!joefritz

References: <13346@garnet.BBN.COM> <580@watserv1.waterloo.edu> <121@tslwat.UUCP>

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!uwm.edu!rpi!joefritz
From: joefritz@pawl.rpi.edu (Jochen M. Fritz)
Newsgroups: comp.sys.ibm.pc
Subject: Re: 386 instructions
Message-ID: <84Q0M&@rpi.edu>
Date: 16 Jan 90 01:50:35 GMT
References: <13346@garnet.BBN.COM> <580@watserv1.waterloo.edu> <121@tslwat.UUCP>
Distribution: comp
Organization: Rensselaer Polytechnic Institute, Troy NY
Lines: 8

Reply to Parent Message