🚀 go-pugleaf

The "push" command (^[p) in MS-Kermit 3.00 sends an XOFF character to
the modem before calling DOS.

Using this to activate DSZ's term mode with a "dsz t" command
causes most remote hosts to freeze.  The remote host can be
unfrozen by keyboarding Ctrl-Q in DSZ's terminal mode.

Since there has been some discussion about file transfer speeds
lately, I ran some tests as long as I had MS-Kermit set up.

SUPK412.ZIP 75136 bytes sent at 2400 bps direct connect from an
Everec 1800 AT clone 8mHz/0ws to an 18 mHz Intel 386 motherboard.

8-Bit line
cps	Protocol/command
156	MS Kermit 3.00 to MS Kermit 3.00  (defaults)
182	MS Kermit 3.00 to MS Kermit 3.00  (windows=2 length=2000)
184	MS Kermit 3.00 to Pro-YAM 17.51 (windows=2 length=2000)
231	Pro-YAM 17.51 ZMODEM (defaults)
237	Pro-YAM 17.51 ZMODEM-90(Tm) MobyTurbo(Tm) (sz -m)

7-Bit line
cps	Protocol/command
156	MS Kermit 3.00 to MS Kermit 3.00  (windows=4 length=2000)
190	Pro-YAM 17.51 ZMODEM-90 PACK-7 (sz -EP)

Kermit transfers used 8 bit CRC, ZMODEM used 32 bit CRC.
Times were measured with a stopwatch.  Your results may vary.

Chuck Forsberg WA7KGX          ...!tektronix!reed!omen!caf 
Author of YMODEM, ZMODEM, Professional-YAM, ZCOMM, and DSZ
  Omen Technology Inc    "The High Reliability Software"
17505-V NW Sauvie IS RD   Portland OR 97231   503-621-3406
TeleGodzilla:621-3746 FAX:621-3735 CIS:70007,2304 Genie:CAF