Article View: comp.sys.intel
Article #1735iPDS EMV51A Emulation Vehicle
From: spalding
Date: Sat, 28 May 1988 22:59
Date: Sat, 28 May 1988 22:59
11 lines
890 bytes
890 bytes
Running the MCS-51 Emulation Vehicle on the iPDS, how do I refer to PL/M-51 line numbers to set breakpoints etc. The PL/M-51 documentation says I can do this, but the EMV51A documentation doesn't say how. I'm getting the symbols (procedure names, labels) ok. I just need an example of the syntax for specifying line numbers in EMV51A commands. BTW, this is EMV51A version 1.2. Thanks, John W. Spalding spalding@p.cs.uiuc.edu
Technical Details
Message-ID:
<80000005@uiucdcsp>Path:
arc1-ca.pugleaf.net!utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!bloom-beacon!gatech!purdue!i.cc.purdue.edu!j.cc.purdue.edu!pur-ee!uiucdcs!uiucdcsp!spaldingShow Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!bloom-beacon!gatech!purdue!i.cc.purdue.edu!j.cc.purdue.edu!pur-ee!uiucdcs!uiucdcsp!spalding From: spalding@uiucdcsp.cs.uiuc.edu Newsgroups: comp.sys.intel Subject: iPDS EMV51A Emulation Vehicle Message-ID: <80000005@uiucdcsp> Date: 28 May 88 22:59:00 GMT Lines: 11 Nf-ID: #N:uiucdcsp:80000005:000:430 Nf-From: uiucdcsp.cs.uiuc.edu!spalding May 28 17:59:00 1988