🚀 go-pugleaf

In article <834613611snz@longley.demon.co.uk>, David Longley
<David@longley.demon.co.uk> writes
>I tried upgrading my BIOS on an Endeavour Board (socket 7 with  6 
>pin J1N1). I am running a P166 so the pins J1N1 are appropriately 
>jumpered.
>
>I have no problem upgrading with version 4. When I try the  above 
>I get a message that the image is corrupt or that the machine can 
>not be flash upgraded?

David, I have a Zappa board which I have upgraded with no problem, You dont say
if you've upgraded this board before, also is your upgrade from the Intel BBS
and the correct upgrade, or some other source, also is the board running at the
moment or are you in the postion of failed post. If however your existing Bios
is currupt there could be a jumper on your board that will allow you to reset.
If its a new Bios then you could download it again and try again. Hope this may
be of help.
Colin Smith.                                      (colskip@colskip.demon.co.uk)
      Dont put off until tomorrow what you can do today, because if you do it 
                 today and like it, you can do it again tomorrow.