🚀 go-pugleaf

In article <timmbake.727752179@mcl> writes:

[ mail bounced to timmbake ... this may not be of general interest ]

>	Hi -- I just installed the 50MHz PowerCache *without* FPU into my MacIIx
>(w/ FPU).  I'm running 7.0.1* w/ 20Meg RAM.
>
>	Now, the only Daystar software I have is PowerCentral 1.3 control panel
>that I downloaded from sumex.  I don't have PowerMath.  Is not having this
>causing my Mac to crash when I open the PowerCentral 1.3 control panel?

The PowerCentral cdev has PowerMath built in.  There is no stand-alone
PowerMath cdev that I know of.  

I'm running a 50 MHz PowerCache with FPU on a 20 meg IIx.  The control
panel does crash when opened under A/UX, but it should work fine with
MacOS.  If that is your problem, just install the cdev in your 
MacPartition sys folder, and configure it properly before launching
A/UX.  If the cache is enabled when A/UX is launched, it will stay
enabled when it is running.

If PowerCentral is crashing under MacOS, call Daystar.  That shouldn't
happen.  I don't know whether PowerMath will work without an on-board
FPU;  what it does is to pass SANE traps to the FPU -- I'm not sure
if it will work with the 16 MHz FPU on the motherboard.
-- 
-- Bill Johnston (johnston@me.udel.edu)
-- 38 Chambers Street; Newark, DE 19711; (302)368-1949