🚀 go-pugleaf

In article <1991Mar30.154206.3484@ux1.cts.eiu.edu>, cfejm@ux1.cts.eiu.edu (John Miller) writes:
> 
> Anybody able to tell me how to do this?:
> 
> One long document, a middle section of which is a table which needs to
> be printed in landscape format rather than portrait.  Sure, I could 
> print them inrtions, but it's nice to work on something all
> at once.
> 
> Ideas?
> 

Apart from doing it in MacDraw (yuk), I am afraid you are stuck
with splitting your doc. into multiple files. You can't print
different pages of a document in different views, and won't be
able to until System 7 arrives I think. Splitting it up is not
really that much of a problem - I have just completed my Master's
Thesis, and it was split up into about 12 sections, each in a
separate file. As long as you set up your "next file" properly in
the Document format dialog, you should be fine.
-- 
See ya
                                Nigel.

/******************************************************************************\
* "If I had a quote, I'd be wearing it."  *  Internet: stanger@otago.ac.nz     *
*       -- Dylan Thomas (I think)         *  SnailMail: Information Science,   *
*                                         *             University of Otago,   *
* "Say no MORE!!!"                        *             P.O. Box 56,           *
*       -- Eric Idle                      *             Dunedin, NEW ZEALAND.  *
\******************************************************************************/