Including PostScript in MS Word documents

Thread View: comp.sys.mac.apps

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by David C. Kovar Thu, 26 Jul 1990 14:26

#3488

Author: David C. Kovar
Date: Thu, 26 Jul 1990 14:26

23 lines
1336 bytes

  I've included a PostScript bitmap from PageMaker 4.0 in a MS Word
document. If I leave everything alone, the bitmap comes out on 
the first page and the Word document comes out on the second.
If I delete the "showpage" from the PostScript it looks like the
bitmap gets "smeared" across the page but the Word document, at
least, prints on the same page.

  I've put PostScript from Illustrator into Word before without
much difficulty. The PageMaker PostScript code tends to be a little
weirder than the Illustrator code.

  This is very annoying. Any suggestions at all would be welcome.
Thanks, in advance.


-David C. Kovar
	Consultant				ARPA: kovar@popvax.harvard.edu
	Eclectic Associates			BITNET: corwin@harvarda.bitnet
	Ma Bell: 617-643-3373			MacNET: DKovar

         "It is easier to get forgiveness than permission."
[All opinions expressed are my own. Noone else assumes responsibility for me.]

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads