Article View: comp.sys.mac
Article #10259Re: Help: Converting Draw II File to PostScript File
From: Chaz Larson
Date: Tue, 23 Jan 1990 03:46
Date: Tue, 23 Jan 1990 03:46
19 lines
1356 bytes
1356 bytes
MacDraw II doesn't have the "print one" command that MacDraw had,
but you can still use the same basic technique you described.
Just select "print..." and, immediately after clicking "OK,"
press and hold Command-F or Command-K [one of these dumps
Laser Prep along with the document's PostScript, but I can't
recall which just now. The filesize will tell you which is
which]. The LaserWriter print window will say "Creating
PostScript file..." instead of "Looking for..." and
somewhere on your drive a "PostScript 0" file will appear.
<chaz>
--
----------------------------------------------------------------------
Chaz Larson - clarson@ux.acs.umn.edu
"Hey, I'm no Jack Kennedy..." - Flaming Carrot
----------------------------------------------------------------------
Technical Details
Message-ID:
<1034@ux.acs.umn.edu>Path:
arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!uc!shamash!umn-cs.cs.umn.edu!ux.acs!clarsonReferences:
<6429@ubc-cs.UUCP>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!uc!shamash!umn-cs.cs.umn.edu!ux.acs!clarson From: clarson@ux.acs.umn.edu (Chaz Larson) Newsgroups: comp.sys.mac Subject: Re: Help: Converting Draw II File to PostScript File Keywords: MacDraw II, PostScript, file conversion Message-ID: <1034@ux.acs.umn.edu> Date: 23 Jan 90 03:46:39 GMT References: <6429@ubc-cs.UUCP> Reply-To: clarson@ux.acs.umn.edu (Chaz Larson) Distribution: na Organization: University of Minnesota, ACSS Lines: 19