🚀 go-pugleaf

In article <7310@goofy.Apple.COM> dwb@archer.apple.com (David W. Berry) writes:
>In article <11315@zodiac.ADS.COM> anders@penguin (Anders Wallgren) writes:
>>Will it be possible to run MPW and SADE under A/UX?  (I suspect the
>>answer is Yes to the former, but I'm not sure about the later)
>	MPW 3.0 and MPW 3.1 both run under A/UX (I compile MultiFinder
>	on them on A/UX) with one minor patch to MPW.  I haven't tried
>	SADE, but I expect it should run.  (I haven't ever managed to
>	make it work under the MacOS, but that's a long story... :-)
	OK.  I'm getting swamped with mail about "How do I patch MPW"
so I guess I'll post the answer.

	**** The following is neither supported or recommended by the
MPW group, the A/UX group, Apple Computer, myself or anybody else that
I know of, it just seems to work for me *****

	1.  While running A/UX, launch MPW
	2.  When it appears to be hung, break into the debugger.  If the
	pc is pointing at a "bra.s *" instruction your in luck, go to the
	next step.  If not, continue and break into the debugger again,
	repeat until you find the "bra.s *".
	3.  Examine the instructions around the bra.s instruction.  You
	are going to use resedit to change the bra.s, so remember them
	well.
	4.  Type "pc=pc+2" to skip over the bra.s instruction.
	5.  Use resedit to change the "bra.s *" instruction to a "nop".
>
>	David W. Berry			A/UX Toolbox Engineer
>	dwb@apple.com


	David W. Berry			A/UX Toolbox Engineer
	dwb@apple.com