Re: MacPlus SIMM upgrade => crashes++

Article View: comp.sys.mac

Article #11810

#11810

From: Steve Dorner
Date: Thu, 12 Apr 1990 16:13

13 lines
1200 bytes

In article <15368@cbnews.ATT.COM> joe@cbnews.ATT.COM (Joseph Judge,45256,cb,1C393,6148607119) writes:
>	My big question would be, where to stick the voltmeter to make sure
>	that you are not over adjusting???

On the bottom of the ANALOG board, where the power connector is soldered in.
Measure voltage between one of the pins and the chassis.

I don't recall exactly which pin it was, and I don't have my documentation
handy.  Try them til you find the one that's closest to +5 volts, and
adjust off that.
--
Steve Dorner, U of Illinois Computing Services Office
Internet: s-dorner@uiuc.edu  UUCP: {convex,uunet}!uiucuxc!dorner

Technical Details

Message-ID: <1990Apr12.161349.13739@ux1.cso.uiuc.edu>

Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!mailrus!iuvax!ux1.cso.uiuc.edu!pequod.cso.uiuc.edu!dorner

References: <807@runxtsa.runx.oz.au> <15368@cbnews.ATT.COM>

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!mailrus!iuvax!ux1.cso.uiuc.edu!pequod.cso.uiuc.edu!dorner
From: dorner@pequod.cso.uiuc.edu (Steve Dorner)
Newsgroups: comp.sys.mac
Subject: Re: MacPlus SIMM upgrade => crashes++
Keywords: SIMM, upgrade, crashes, power
Message-ID: <1990Apr12.161349.13739@ux1.cso.uiuc.edu>
Date: 12 Apr 90 16:13:49 GMT
References: <807@runxtsa.runx.oz.au> <15368@cbnews.ATT.COM>
Sender: usenet@ux1.cso.uiuc.edu (News)
Reply-To: dorner@pequod.cso.uiuc.edu (Steve Dorner)
Organization: University of Illinois at Urbana-Champaign
Lines: 13

Reply to Parent Message