🚀 go-pugleaf

In article <3117@husc6.UUCP> stew@endor.UUCP (Stew Rubenstein) writes:
>In article <6635@apple.UUCP> rpd@apple.UUCP (Rick Daley) writes:
>>There is an A/UX manual called "The A/UX Toolbox Guide" that goes into detail
>> about what applications do that keep them from working under A/UX.
>
>How can a certified developer get a copy of that manual so that I
>can write my applications in such a way that they WILL run under A/UX?
>
Well, some pointers on how to be good.

* Do not assume 24 bit addressing.  Do not stuff anything into the topmost 
byte of a handle

* Do not used 68000 priviledge instructions.  A/UX Toolbox applications 
run in user mode,

* Do not directly address hardware.

* Do not use low memory globals if at all possible.

Of course, many of these "restrictions" are actually good Macintosh programming 
practices.  In general, do not make a lot of assumptions about the current 
Macintosh programming model as it is subject to change, e.g. A/UX toolbox
access is a modification on the Macintosh programming model.  Applications that
make assumptions about the programming model (i.e. a lot of them) will break.


/*--------------------------------------------------------------------------*/
/*  NOTE: I am _NOT_ an Apple representative.  All statements and opinions  */
/* are my own and are _not_ to be construed as any official Apple position. */
/* Byron B. Han                 UUCP: {sun,voder,nsc,mtxinu,dual}!apple!han */
/* Apple Computer, Inc.        CSNET: han@apple.csnet                       */
/* 20525 Mariani Ave MS 27Y    GENIE: BYRONHAN         CSERVE: 72167,1664   */
/* Cupertino, CA 95014        ATTNet: 408-973-6450  APPLELINK: HAN1         */
/*--------------------------------------------------------------------------*/