Re: SF&I

Article View: comp.sys.mac

Article #3159

#3159

From: Ken Mitchum
Date: Thu, 17 Aug 1989 20:20

7 lines
720 bytes

Most likely, you need to turn off the "Unit Attention on Reset" feature
of the ST277N. This is done via page 0 of the mode select command.
A while back I posted a version of SF&I for the 277N that included this
during the formatting. I think someone put a copy on Sumex.

 Ken Mitchum
 km@cadre.dsl.pitt.edu

Technical Details

Message-ID: <3269@cadre.dsl.PITTSBURGH.EDU>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!watmath!att!ucbvax!tut.cis.ohio-state.edu!pt.cs.cmu.edu!cadre!km

References: <839@cf-cm.UUCP>

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!watmath!att!ucbvax!tut.cis.ohio-state.edu!pt.cs.cmu.edu!cadre!km
From: km@cadre.dsl.PITTSBURGH.EDU (Ken Mitchum)
Newsgroups: comp.sys.mac
Subject: Re: SF&I
Message-ID: <3269@cadre.dsl.PITTSBURGH.EDU>
Date: 17 Aug 89 20:20:55 GMT
References: <839@cf-cm.UUCP>
Reply-To: km@cadre.dsl.pitt.edu (Ken Mitchum)
Organization: Decision Systems Lab., Univ. of Pittsburgh, PA.
Lines: 7

Reply to Parent Message