🚀 go-pugleaf

In article <15569@agate.BERKELEY.EDU>, c60a-2ce@e260-2b.berkeley.edu (Mikey) writes:
> 
> I don't know why, but a lot of my NEW blank disks will not initialize.
> I've tried both 400k and 800k formats; neither work. Are there any
> utilities out there that can seal off just the bad blocks so the
> entire disk won't be wasted?

I tried sending e-mail but got a "host unknown" msg.  Besides, I think others may
have or will eventually run into this problem.

I had this problem happen to me, too!  Then I discovered that my floppy drive
(a 800k DS Apple internal floppy drive) had broken...the disks were fine, it 
was the drive that was bad.

I don't like being the bearer of bad news but I strongly suggest you go to your 
nearest Apple dealer and get it checked out.  If they say it is ok, then maybe 
you got a batch of bum diskettes (but I doubt that).

My floppy drive cost about $175 to get replaced, that was with the trade-in of 
my broken one, and included installation.  This was at Businessland.  You may be 
able to do better.  Hope this helps...

--Bruce


-- 
-----------------------------------------------------------------------------------
** These are my opinions, & not necessarily those of Mentor Graphics Corporation **
Bruce Holm, Design/Analysis Div. | USENET: bruceh@pdx.MENTOR.COM   
Mentor Graphics Corp.            |   UUCP: ...!{sequent,tessi,apollo}!mntgfx!bruceh