🚀 go-pugleaf

In article <854@eutrc3.urc.tue.nl>, rcstfdb@eutrc3.urc.tue.nl (Frank WGM de Bruyn) writes:
> In article <13725@shamash.cdc.com> pwp@shamash.UUCP (Pete Poorman) writes:
  >In article <829@eutrc3.urc.tue.nl> rcstfdb@eutrc3.urc.tue.nl
  >    (Frank WGM de Bruyn) writes:
  >
  >>PROBLEM: Imported draw graphics (PICT) will show alignment errors 
  >>when reduced (e.g. 60 percent) within MS Word (both vs. 3.x and 4.0).
   
  >
  >To work around, either turn off Fractional Widths in MacDraw and re-copy your
  >PICT, or turn on Fractional Widths in Word.
  
> Sorry Pete, No Go: fractional widths only influences text, I can demo
> the problem using only rectangles and/or lines drawn on a grid to
> assure allignment.


I had some problems getting some of my drawings to align as well.  I
eventually didn't fix it and let it ride.  However, I found a few ways
to to work around it, basically I remember being careful in my
scaling of drawing parts within draw before importing into Word.  This
was 1.9.5, I think Draw II fixed the problem (at least partially).


-- 

Rusty "No Bugs" Hodge, 1588 N. Batavia St. Orange, CA 92667 Tel (714) 974-6300
rusty@hodge.cts.com [uunet zardoz crash]!hodge!rusty        FAX (714) 921-8038