🚀 go-pugleaf

In article <8901092156.AA06911@decwrl.dec.com> fortmiller@hpscad.dec.com (Ed Fortmiller) writes:
#>When I'm printing mailing labels on a IW-II using 4th Dimension
#>1.0.6 and 6.0.2 it prints 10 of them and skips one then 10 more
#>and skips. The layout has H set to 0, and B,D,F to 1". The
#>variable is in a box that goes from 0 to 7/8" and I concatenate
#>the entire address to that variable. How can I cure this skipping
#>problem? The actual labels are 15/16" and come every 1". When I'm
#>in the layout I notice a grey somewhat thick line around the
#>10.25" mark which I see no mention of in the manuals and I don't
#>know if that has anything to do with it or not.

I assume that this is a laserprinter. There is an area
near the edges of the page in which a laserprinter can't
print. Personally, I print labels on an LQ for that reason
and also because I can run continuous labels on it. I don't
use 4th Dimension but presumably it either has a canned program
or else you can write a program to print labels on it.