🚀 go-pugleaf

In article <8901092156.AA06911@decwrl.dec.com> fortmiller@hpscad.dec.com
(Ed Fortmiller) writes:
>When I'm printing mailing labels on a IW-II using 4th Dimension
>1.0.6 and 6.0.2 it prints 10 of them and skips one then 10 more
>and skips. The layout has H set to 0, and B,D,F to 1". The
>variable is in a box that goes from 0 to 7/8" and I concatenate
>the entire address to that variable. How can I cure this skipping
>problem? The actual labels are 15/16" and come every 1". When I'm
>in the layout I notice a grey somewhat thick line around the
>10.25" mark which I see no mention of in the manuals and I don't
>know if that has anything to do with it or not.

I hate to say this, but you've hit one of the hundred or so bugs that I
reported to Acius about 19 months ago (yes, that's well before they
shipped :-).  In a variety of situations (perhaps always, I don't remember)
Fourth Dimension can't print reports with footers (or was it breaks?)
because they cover up detail lines. Print your report without a footer. At
least you'll get the detail lines. Or you can wait for 4D 2.0... If they fix
it.

Or you can buy FoxBase. (1.2Beta is in my greedy little hands, and it's
incredible. More on that in a few days.)

Alexis Rosen
alexis@ccnysci.uucp