🚀 go-pugleaf

From article <524@bridge2.3Com.Com>, by kat@bridge2.3Com.Com (Keith Tomkins):
> heard that there is a package called SoftPC that will allow me to do this.
> I need the answers to the following questions:
> 	1. Will this run on a MAC SE?
> 	2. If so, do I need an accelerator or does it run relatively quick 
> 	   on a stock SE?
> 	3. If it only runs on a MAC II, should I get an accelerator for it?
> 	4. Approximately what does the package cost?
> 	5. What are the known bugs?
> 	6. Will it run graphics oriented (i.e. CAD) packages on it?
> 
	1.  No, it won't run on the Mac SE.  You must have an accelerator card
		and at least 2 megs of  memory.  It is slow with the 2 meg
		version, and about XT speed with the 4 meg version.
	2.  See one.
	3.  Mac II is about the same as a good accelerator in the SE.
	4.  $500 mail order?
	5.  I don't know of any.
	6.  Don't know.
	Hope that helps.  A good friend of mine has it and uses it a lot.  He
	has a 68030 @ 20MHz with 5 meg of memory.  You NEED a hard disk.
	Jim