🚀 go-pugleaf

The "generating-postscript" file on sumex-aim.stanford is too
skimpy.  Can we put the following, expanded file on that machine?  Who
is the moderator I would send this too?  Thanks.

------------------------------------------------------------ 

First, get a hold of some laserwriter/laserprep icons.  There are
several versions of postscript; your printer may not implement the
latest version.  Therefore, it may not be good to use the latest
NT/NTX icons, since these assume a very recent version of postscript.
For instance, it seems necessary to use the older Laserwriter / Laser
Prep 4.0 icons of April 14, 1987 with imagen printers, whose
ultrascript language is an early clone of postscript.  If you
consistently get postscript version errors when you print, then
perhaps you should consider looking for these older icons.

To generate a Postscript file from any Macintosh application, first go
to the chooser, tell it you have appletalk hooked up (lie).  If you
really are using appletalk, then you will have problems if there is no
laserwriter on the network.  In this case, perhaps you will be forced
to disconnect the appletalk cable from the back of your machine.

Then select the LaserWriter (not the LaserWriter SC driver.)  Turn
Background Printing off if you are using MultiFinder.  This will cause
small formatting changes in most word processors, since the
laserwriter has larger characters than the Imagewriter or other
printers.  Go to your word processors and correct the lines that have
now changed.  It is a good idea to leave the laserwriter selected
all the time, if possible, so your documents are created with these
changes already in place.

Get ready to print the document in the normal fashion.  When you see
the LaserWriter dialog, click on OK and immediately type and hold
either the K key or the F key. You must depress the key immediately
within the first 1-2 seconds AFTER the dialog disappears.  Do not use
command-F or command-K, as there might be problems in depressing the
key too soon after clicking OK on the dialog.  If you get a message
"looking for laserwriter", then you probably hit the key too late.
The only difference between these commands is that command-K
prepends the contents of Laser Prep to your Postscript output. This is
essential if you are printing to a non-Apple printer.

You should see a file called Postscript0 appear in the current folder.
The next time you do it, if Postscript0 already exists, Postscript1
will be generated, etc.

Keep in mind that if you are uploading this to another system (UNIX),
a normal postscript file has its lines terminated by control-M.  Many
UNIX upload programs will attempt to convert control-M to control-J.
Therefore, upload the postscript in BINARY mode, if possible.

It is possible to upload a laserprep file once, and then save
uploading it in future sessions.  Just generate an empty postscript0
file, and edit it to extract the laserprep part.  Upload this 28K file
once, and you will save a lot of time in future sessions.

------------------------------------------------------------

Don Gillies, Dept. of Computer Science, University of Illinois
1304 W. Springfield, Urbana, Ill 61801      
ARPA: gillies@cs.uiuc.edu   UUCP: {uunet,harvard}!uiucdcs!gillies