CADKEY/IGES/HPGL to Mac PostScript conversion

Article View: comp.sys.mac

Article #6843

#6843

From: keithr
Date: Tue, 24 Oct 1989 20:24

20 lines
1397 bytes

A friend of mine has asked me to post this message:

  I am a technical illustrator using Adobe Illustrator 88 on a Mac II
  to create mostly isometric views of mechanical components for
  publication.  The design engineer in my division creates his 3D
  geometry in CADKEY running on a Compaq 386.  CADKEY produces files 
  formatted in IGES and HPGL.  My question is:  How may I most efficiently
  make use of the engineering 3D geometry, and its viewing options
  (orthographic, isometric, perspective) to create my illustrations?

  Are there programs that convert PC HPGL to Mac PostScript?  Should I set
  my views up in CADKEY, print them out, then scan them for templates?
  What in your view is the optimal solution?

Please email me any responses.  Thanks in advance for any information you
can give.



-Keith Rowell, Tektronix, Wilsonville, OR   keithr@orca.WV.TEK.COM

Technical Details

Message-ID: <5104@orca.WV.TEK.COM>

Path:

arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!uunet!zephyr.ens.tek.com!orca!tolkien.WV.TEK.COM!keithr

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!uunet!zephyr.ens.tek.com!orca!tolkien.WV.TEK.COM!keithr
From: keithr@tolkien.WV.TEK.COM
Newsgroups: comp.sys.mac,comp.sys.ibm.pc
Subject: CADKEY/IGES/HPGL to Mac PostScript conversion
Message-ID: <5104@orca.WV.TEK.COM>
Date: 24 Oct 89 20:24:17 GMT
Sender: nobody@orca.WV.TEK.COM
Reply-To: keithr@tolkien.WV.TEK.COM ()
Followup-To: comp.sys.mac
Distribution: na
Organization: Tektronix, Inc., Wilsonville, OR
Lines: 20