🚀 go-pugleaf

Two items:

1) I've just finished installing GNUemacs 18.53 on our group of
   Masscomps (RTU 4.0; 5700,5400s & 5520s) with absolutely no problems;
   just use the ucb universe and make it with the provided m-masscomp.h
   & s-rtu.h after setting up the local paths.  I just remembered 1
   extra thing I had to do; compile everything BUT loadst in the ucb
   universe.  When compiled in ucb loadst always says you have new
   mail; it works fine when compiled in the att universe.

2) Now, we've also got a single Next on our network and I'd like to
   bring up 18.53 on it (0.9 comes with pre-compiled 18.52) so we have
   the same version running on everything.  Also a lot of us here have
   vt100-style terminals and like to use edt-emulation; the goldkey
   code is broken in 18.52 but works fine in 18.53. 

Does anyone have m-next.h and s-mach.h for this version on a 0.9 Next?
If need be we can write them ourselves, but I'd rather not have to 
spend the extra time to figure out the special stuff needed for the
Next, especially since Next already knows it.

Thanks, 
rick
--
Rick Gray                               uucp:{uunet,shell,rice}!soma!rick
Department of Neurology		    Internet: rick@soma.neuro.bcm.tmc.edu
Baylor College of Medicine 
Houston, Tx 77030

Articles to: masscomp@soma.bcm.tmc.edu or uunet!soma.bcm.tmc.edu!masscomp
Administrative stuff: masscomp-request@soma.bcm.tmc.edu
Stan Barber, Moderator