Micropolis 1325T help needed

Thread View: comp.sys.misc

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by 8718 Mon, 13 May 1991 02:11

#682

Author: 8718
Date: Mon, 13 May 1991 02:11

11 lines
950 bytes

I have a micropolis 1325T (ST-506 interface) which I am trying
to get running on a Tandy 6000. I keep getting a "Drive Not Ready"
diagnostic when I try to format it. I doubt I have a controller
problem (but possible) and my suspicion is that a component on
the drive board has failed. I need either a schematic (or source
of) the board that is on the drive or (less desirable) the
pin ID of the "Drive Ready" signal.

Any help much appreciated!

Thanks from Tom "The Old" Mann.

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads