🚀 go-pugleaf

bohlke@nextwork.Rose-Hulman.Edu (Jon H Bohlke) writes:


>David,
>   My manual told me that I had to have hardware flow control for my ZyXel 14.4  
>v.42bis connection.  Is that available on an 68030?

>Jon
>In article <55184@athertn.Atherton.COM> dlw@atherton.com (Remo Williams) writes:
>> Just got my ZyZel U1496E (for $350 by the way) and plugged it into my NeXT (030  
>> cube) and cranked up Microphone II with the speed setting in Microphone set to  
>> its highest level (38xxx). I can connect up ok to the 2 systems I normally  
>> call.
>> 
>> However trying to do a download of files with either
>> 
>> On Unix, the sz command (on the remote unix host side)
>> or WWIV macintosh bbs (zmodem download)  
>> 
>> simply generates transmission errors my side. I have made no settings  

The fastest I've gotten an 030 cube to do zmodem reliably (no
errors) with IComm has been 9600 bps.  Others have gotten 19.2 with
few retries, but you can't be doing anything else at the same time.
38.4 is right out.
(The 030 certainly does not support hardware flow control, as
documented in about a hundred places, the least of which is the 'zs'
man page)
-- 
David Lemson                                                 (217) 244-1205
University of Illinois NeXT Campus Consultant  / CCSO NeXT Lab System Admin
Internet : lemson@uiuc.edu                 UUCP :...!uiucuxc!uiucux1!lemson 
NeXTMail accepted                                   BITNET : LEMSON@UIUCVMD